Wirenet Mic

  • November 14, 2012
  • Blender 2.6x
  • Render: Blender Internal
  • Creator: tahseen
  • License: CC-BY
You must be logged in to download.


Modeled this wirenet mic after failure using other methods I thought I could use. There is no method given on net on how to make this. And I had to struggle a lot.

Proportion might not be correct because the focus was on making the wirenet. Next time I make it again, it would be much better as now I know how to make it.


  • nickbrunner profile picture

    Very cool! Well done!

    Written November 14, 2012
  • tahseen profile picture

    Thanks Nick :-)

    Edited November 14, 2012
  • bashi profile picture

    Nice. The Way i found to do the Net is by Cast Modifier and a Arrayed Spline. See here if you want to: http://www.pasteall.org/blend/17507 (you probably should apply the modifiers and then delete or boolean cut out what you dont need)

    Written November 15, 2012
  • tahseen profile picture

    Cast modifier distorts the shape at the top if you are using sphere as the cast.

    Also observe that my mesh is going between each other. In your case, one wire is always on top of other.

    I did use cast modifier in the beginning but it turned out to be problematic

    Written November 20, 2012
  • nathanferguson profile picture

    Brilliant render :D Looks realistic to me!

    Edited November 16, 2012
  • Aye profile picture

    Awwwwesome! Much respect man!

    Edited November 28, 2012
  • zamer profile picture

    It's very nice !

    Written November 13, 2013
  • RahulParihar profile picture

    How did you make the wirenet ?? I tried many methods but couldn't make one as accurate as yours. What technique do you use sir ?

    Written November 16, 2013