P90
- October 01, 2011
- 215 Downloads
- 0 Likes
- Blender 2.5x
- Render: Blender Internal
- Creator: mrchaoslama
- License: CC-BY-SA
Description:
This is my New model! it's a P90 Sub machine gun. I Tried something new, I baked the ambient occlusion. I personally think it looks good other than the weird black spotty bits but who cares if you like the model then you like the model and the textures aren't really too important. If you re-Texture this i don't care if you upload this on your blendswap just give me credit for the model.
Comments:
-
Bobson
Written October 02, 2011Nice start but needs lots of work.
Jay-Artist has pretty much covered most of them, I think you could have optimised the model more and lowered the total face count.
Lots of wasted faces going through the center of the model.
Also 19 edges connected to 1 vert, I think is not a great idea.
-
mrchaoslama
Written October 03, 2011@ Jay-Artist Thanks your tips really helped i've only been using blender since May-ish and that's really helped. I have Fixed a lot and used the remove doubles tool then re-baked the ambient occlusion and i've gotta say it looks a lot better. I'd like to e-mail you it so you can make sure it looks good before i upload it to Blend Swap so could i have your e-mail address? oh yeah the sub division messes up the model, it looks good almost everywhere but around the rails it looks wrong and i don't know how to apply the modifier to just the selected part of the model.
-
mrchaoslama
Written October 03, 2011@ Bobson Hey Bobson i haven't seen one blend posted by you so i don't know if you can do better i believe you can as i'm not really very experienced in any 3d art type things. Could you tell me where the 19 edges to 1 verticie is? so that i can fix it. Thanks in advance.
-
Bobson
Written October 04, 2011Here's a screenshot:
http://db.tt/Shx05gwF
Same on the other side also.
Thanks for letting me know that my blend is not showing on my profile, I'll have to contact an admin about that.
Hi Mrchaoslama,
Forgive me if I'm wrong though as I haven't downloaded the model at present - I'm just looking at the render for the moment.
I think you have some topology issues, looking at the render it appears you have duplicate faces, possibly inconsistant normals, or several unjoined vertices.
Might I suggest you go into edit mode and select the whole mesh and press "W" then choose "Remove Doubles".
You can flip normals by pressing CTRL+N, then double check that nothing else is amiss.
Also you may like to try usung a 'Subsurf modifier' to smooth things out, as the model looks rather rough all over - unless this was you're intention - although note you'll probably require more edge loops if you do use the subsurf. :)